The server hosting the RCS has its firewall enabled. I cannot connect to it using SCS Console from client PC or from the SCCM server during SCCM Add-on installation. I know there is a small section in the manual that states:
--------------------------------
If you install the RCS on a computer that is protected by a firewall, you might receive error messages when you
try to connect to the RCS.
Solution:
You must make sure that the firewall is configured to enable the WMI to connect to the RCS. For more
information, refer to the Microsoft Developer Network:
http://msdn.microsoft.com/en-us/library/aa389286(VS.85).aspx
--------------------------------
However this doesn't help in any way. I click the link but the page talks about using VBScript? If I disable the firewall on the RCS server I can connect so it's obviously a firewall issue, the question is which port/s do I need to open? If I capture the traffic on my PC whilst trying to connect to the RCS server I see attempts to connect on port 135 except I have tried enabling the rule "Windows management Instrumentation (WMI-In)" on the server but no luck.
Any ideas?
Graham